ENGLISH
Congratulations! You just bought the best compressor on the market.
Read the following booklet carefully and follow its instructions before you start using the machine in order to avail yourself of its
potentialities without endangering your safety or damaging the appliance.
This CE mark indicates that the compressor meets with EEC Directives 2006/42/EC, 2009/105/EC, 2004/108/EC, 2002/95/CE,
2002/96/EC, 93/68/EEC, EN292/2, EN 294, EN 60204-1.
Safety precautions
Strictly observe the following safety measures:
1.
Move the compressor by suitable means to avoid an excessive effort to the upper and lower limbs.
2.
Sound pressure is below 80 dB (A), however in case of prolonged use and recommended the use of protectors such as
headphones.
3.
Do not move the compressor in operation may cause health risks for exposure to vibrations of limbs (hand-arm).
4.
If not operating, no electrical or mechanical repair of any kind. Contact your supplier immediately.
5.
Do not use in environments that do not allow proper circulation of air.
6.
Do not spray toward flames, heat sources, people and animals.
7.
Please avoid, above all in very hot climates or during summer, a prolonged exposure of the machine to the direct rays of
the sun, in order not to overheat plastic parts, the working temperature should be b5 and +50 ° C.
8.
Keep away from the function of children and animals.
9.
Do not use the compressor in humid or dusty.
10.
Do not tamper with safety devices and regulation.
Starting the machine.
Make sure no damages due to carelessness or negligence occurred during transportation, before you start
the machine. If this should be the case, notify the dealer or transportation company immediately. After having checked the
equipment observe the following instructions:
a.
Remove the electric cable and insert the plug in a current collector of adequate power. Make sure if fits tightly and it
ensures the connection of the poles of the plug to the grounding. Make sure the mesh voltage corresponds to the value
indicated on the table of the fairing.
b.
To help the electric motor start, make sure the air hose in not under pressure and the air outlet cock (ref. 7 fig. A) is open.
c.
Start the electric motor by operating on the switch (ref. 2 fig. A).
Use.
The compressor is equipped with an air flow adjuster (ref. 6 fig. A) which enables the operator to control the working
pressure. Said pressure is measured with a manometer (ref. 8 fig. A).
Connect the chosen accessory to the air outlet cock (ref. 7 fig. A) and, keeping it closed, operate on the knob of the regulator (ref. 3
fig. A) until the desired working pressure is reached. After this operation is completed, open the cock until the needed air capacity
is reached. Keep in mind that, by alternately adjusting both the regulator and the cock, an optimal pressure air ratio can be
obtained.
Turning the machine off.
The compressor is equipped with an air pressure switch (ref. 3 fig. A) which automatically control the
starting and turning off procedures of the compressor electric motor; nevertheless, to stop the compressor independently from the
air pressure switch, use the general red switch (ref. 2 fig. A).
IMPORTANT: Never stop the motor by unplugging the unit! This should be done when the compressor already switch off.
Maintenance.
Unscrewing the filter (ref. 1 fig. A) clean it periodically by an air jet moving from the center to the outside. Because
of the compressor and rapid expansion of the air inside the tank, the humidity in the air condensates. It is therefore necessary to
periodically discharge the condensate from the tank by unscrewing the drain plug (ref. 5 fig. A) and slightly tilting the tank.
Important.
The electric motor is protected by a thermic circuit breaker: said protection device is activated when the motor
overheats and causes sudden stop or intermittent workings.
In this case, make sure that:
a.
The network voltage corresponds to the one indicate on the label.
b.
The maximum calibration pressure of the pressure switch is less than or equal indicate on the label.
c.
No strange noise or vibration is notes when the compressor is functioning.
Warranty.
The compressor s guaranteed for a period of 12 months from purchase date for construction faults. It is important to
keep to original purchase document to vouch for the validity of the warranty. It is furthermore necessary to use the compressor as
indicated in this booklet and to show it has not been tampered with. The warranty covers only the replacement of those parts
which are faulty because of assembly or manufacturing defects. All transportation or operation fees are charged to the clients.
Recycling
: Please dispose of the compressor in the environment as waste. The compressor must be collected as
electrical and electronic equipment separately.
