1. Overview
AirLive SP-101 User Manual
3
Or If your controller requires to have
the Plug send a 'node information
frame' or NIF for associations, then
pressing the On/Off button three times
within 2 seconds will cause the Plug
to send its NIF.
2. There are only one group for the
switch
※
Including a node ID allocated by Z-Wave Controller means inclusion. Excluding a node
ID allocated by Z-Wave Controller means exclusion.
※
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
1.2 LED Indication
To distinguish what mode the switch is in, view from the LED for identification. The
color of LED could be blue
、
cyan
、
green
、
orange
、
pink or red, it represents the power
consumption from light to heavy.
State Type
LED Indication
Normal
Under normal operation, toggle On/Off button between On and Off.
When pressing On, LED lights up, whereas Off, LED is off.
No node ID
Under normal operation, when the Switch has not been allocated a node
ID, the LED flashes on and off alternately at 2-second intervals. By
pressing On/Off button, it will stop flashing temporarily.
Learning
When Plug is in learning mode, LED flashes on and off alternately and
repeatedly at 0.5 second intervals.
Overload
When overload state occurs, the Switch is disabled of which LED flashes
on and off alternately at 0.2 second intervals. Overload state can be
cleared by unplugging and reconnecting the Switch to the wall outlet.
1.3 Choosing a Suitable Location
1. Do not locate the Switch facing direct sunlight, humid or dusty place.
2. The suitable ambient temperature for the Switch is 0°C~40°C.
3. Do not locate the Switch where exists combustible substances or any source of heat,
e.g. fires, radiators, boiler etc.
4. After putting it into use, the body of Switch will become a little bit hot of which
phenomenon is normal.
1.4 Installation
1. Plug this On/Off Switch into a wall outlet near the load to be controlled.
