3.
AirLive N450R User’s Manual
88
. Beacon
Interval
The device broadcasts beacon frames regularly to announce its existence. The
ifies how often beacon frames are transmitted in time unit of
d
3.
used to gain control of the medium for transmission. Any unicast
mes larger than specified RTS threshold must be transmitted
that
5.
tation threshold, it will be
the transmission. It should have a value of 256-2346 bytes, with a
6.
s that operate in the power-saving mode.
(DTIM) informs such power-conserving
alue
7.
power of the N450R. The higher the output power,
erage N450R can deliver. However, it is advised that you use just
p
Configuration
2
beacon Interval spec
milliseconds. The default value is
100
, and a valid value should be between 1 an
1000.
Transmit
Power
4. RTS
Threshold
RTS/CTS frames are
(data or control) fra
following the RTS/CTS handshake exchange mechanism. The RTS threshold should
have a value between 256-2347 bytes, with a default of
2347
. It is recommended
this value does not deviate from the default too much.
Fragmentation
When the size of a unicast frame exceeds the fragmen
fragmented before
default of 2346. If you experience a high packet error rate, you should slightly
decrease the Fragmentation Threshold.
DTIM
interval
The AIRMAX5 buffers packets for station
The Delivery Traffic Indication Message
stations that there are packets waiting to be received by them. The DTIM interval
specifies how often the beacon frame should contain DTIMs. It should have a v
between 1 to 255, with a default value of 3.
WMM
Capable
Enable or disable WMM Capable.
8. TX
Rates
You can adjust the transmit output
the larger cov
enough output power so it will not create excessive interference for the environment.
Also, using too much power at close distance can create serious performance dro
due to signal distortion.
