WWW.AIRLESSCO.COM TEL: 805-523-0211 FAX: 805-523-1063
Email: [email protected]
WWW.AIRLESSCO.COM TEL: 805-523-0211 FAX: 805-523-1063
Email: [email protected]
• Always consider which way the wind is blowing to
avoid overspraying.
• Spray surface conditioners so you are “Up Wind”.
• Never allow surface conditioners, soap or other chemi-
cals to get on vegetation. Use plastic sheeting to protect.
• Keep the quick couplers out of dirt and sand. If they
should have dirt or other debris on them, clean the quick
coupler thoroughly before using.
• Do not allow your hand or body to come in contact with
water spray. HANDLE AS YOU WOULD A LOADED
FIREARM!!
REMEMBER, although prepertion is hard work it will mean extra years of good
protection and good looks.
0º For Power Blasting -
Delivers very concentrated stream of water. Exercise caution as the
impact force can damage soft surfaces.
15º For Chiseling & Stripping Action
-
Quickly removes blistered and peeling paint or other
residues. Spray should be directed at 45° angle.
25° For Power Cleaning & Flushing -
The perfect wider spray angle for effectively washing
away dirt, mud and grime.
40º For Moderate Washing &
Rinsing -
Its wide spray pattern “sweeps” surfaces clean.
• Select the right tip for the job.
• Never allow anyone into your work area & risk injury.
• Approach target from a slight angle (“sweep” surface).
• Always wear face shield and eye protection.
• Turn machine off and relieve pressure from hose &
system before disconnecting hoses, control handle
(gun) or tips.
• Cover any exposed electrical sockets, plugs, lights or
other exposed electrical connections.
• Do not kink the high pressure hose, the wires inside
may bend and become weak or break.
GET THE MOST FROM YOUR MACHINE
To Operate Unit:
1.
Select desired nozzle. Lock control handle (gun or
wand) off and install nozzle in quick coupler
at end of wand. Insure that coupler sleeve is
properly locked by pulling on nozzle.
2.
Start engine according to engine manual.
3.
Unlock control handle (gun or wand), point
wand at ground and operate to test.
4.
Adjust pressure of spray to desired level.
To Use
Chemical Injector:
1.
Push end of chemical pick-up tube onto injector inlet.
2.
Place filter end of pick-up tube in container of chemical
to be dispensed. Unit mixes chemical with water.
Ratio is adjustable.
3.
Attach proper nozzle to wand. (Injector will draw
chemical only with special large orifice, fan pattern
nozzle supplied).
4.
Operate control handle as usual.
5.
After use, remove nozzle from wand and place pick-up
tube filter end in container of water. Flush out tube by
operating gunjet.
TO REMOVE PEELING PAINT:
1.
Start at the highest point. Use a 15 degree nozzle.
2.
Spray should be directed 4"-12" from the surface at an angle of 45 degrees. This will allow you to work the
spray like a chisel.
3.
On the soffit, peel at a parallel angle. It will peel off in large sheets if you can get beneath it.
4.
Spray in a back & forth motion always trying to get beneath the peeling paint. Be sure to get as much paint off as
possible & don’t be concerned about the paint that remains, it is bonded well enough to not cause a problem.
5.
If paint edges curl up after being pressure washed, use a scraper or steel brush on these areas.
6.
Remove loose putty around windows.
7.
Spot prime any bare wood areas. When primer has dried apply putty and caulking as necessary.
USERS GUIDE
6
