Adjusting the swing-away elevating leg rest
(models no. 700-426 and 700-428)
1.
To adjust the elevating leg rest, raise legs until the desired height
is obtained.
2.
To reposition leg rest to normal position, support leg with one hand
and push release handle downward with the other hand.
3.
To adjust the calf pad, turn the pad towards the outside of the wheelchair.
4.
Slide the calf pad up or down until the desired position is obtained.
5.
To secure the calf pad, turn the calf pad towards the inside of
the wheelchair.
14
15
Adjusting the wheel locks
1.
Ensure the wheel-lock is in the open (unlocked) position.
2.
Loosen the bolt & locknut that secure the wheel-lock to the
wheelchair frame.
3.
Adjust the position of wheel-lock until the measurement between the
rear wheel and the wheellock shoe is between 1/4 and 13/32 inches.
4.
Securely tighten the bolt & locknut.
5.
Engage the wheel-lock and push against the wheelchair to determine if
wheel-lock engages the wheel-lock shoe enough to hold the wheelchair.
6.
Repeat the above procedures until the wheel-lock holds the wheelchair.
REAR
WHEEL
1/4” - 13/32”
(6.4 - 10.3 mm)
WHEEL-LOCK
SHOE
WHEEL-LOCK
HANDLE
BOLT & LOCKNUT
UNLOCKED
POSITION
PULL TO LOCK
LOCKED
POSITION
TO REMOVE DETACHABLE DESK ARMS (IF APPLICABLE)
1.
Push in the button lock at the front base of the arm.
2.
Lift the arm up and off.
TO REPLACE DETACHABLE DESK ARMS (IF APPLICABLE)
1.
Reposition the arms.
2.
The button lock will automatically snap in place.
