Airflow Systems V410, Руководство пользователя

Страница: 11 / 50

A4
MAINTENANCE
WARNING
ALWAYS DISCONNECT THE UNIT FROM THE POWER SOURCE
BEFORE WORKING ON OR NEAR THE MOTOR OR WIRING
ASSEMBLIES. LOCK OUT DISCONNECTS TO PREVENT UNEXPECTED
APPLICATION OF POWER.
The Model V410 comes standard with (2) CLEAN 2

filter cartridges of 150 square feet of media each.
An optional External Module is available for a final filter. This external module can house either a HEPA
filter or an adsorption bank (AD). Filter access is from the top cover of the module.
The Adsorption Module (AD) is a refillable, finely perforated container to hold the adsorption material in
the air flow. As with the HEPA, it is located on top of the unit. The AD utilizes the same mounting method as
described above. The AD module has a 2" 30% poly after-filter to remove any carbon (or other) dust that
occurs from adsorption material breakdown.
VIBRA PULSE

SYSTEM MAINTENANCE - HOSE REPLACEMENT
The Vibra Pulse

hose that is used to clean the filter will eventually wear out. Check for signs of excessive
wear when doing normal filter service or if a decrease in filter cleaning effectiveness is observed. A hose
should be replaced when it has worn to a length of 6”. Replacement of the hose is a simple operation. With
the unit turned off, disconnect power and lock out.
CAUTION: Disconnect Air Supply before working
on unit. Proceed as follows to accomplish the hose replacement.
1. Turn unit off. Disconnect power and lock out.
2. Disconnect air supply before working on unit and lock out.
3. Remove filter access door.
4. Remove cartridge filter(s) from unit.
5. Remove dust tray and dispose of material in accordance with local, state, and federal regulations.
6. The Vibra Pulse

actuator mechanism consists of the following:
1 fixed and 3 loose components (per filter), see Figure 7.
a. Fixed component is the 3/8” rigid hose barb attached to the Vibra Pulse

Plenum chamber
b. The loose components involved in the replacement operation consist of:
1 - Reusable spring (7PR1-2004)
1 - Reusable hose clamp (7HG3-1003)