7
）
Twist the Quick Release Cord Wrap clockwise to unwrap the Power Cord completely and plug into a grounded outlet .
8
）
When plugged in
，
water tank window becomes red. After 25 seconds, window changes to blue. Blue means the Mop is
ready to emit steam.
9
）
Slowly pass over surface to be cleaned. It is recommended to sweep or vacuum floor prior using the Steam mop.
NOTE:
It is recommended that another high wattage appliance is not operated on the same circuit to avoid a circuit
overload.
CAUTION:
To sanitize an area of your floor, leave the Steam mop over area for a minimum of 8 seconds, but no longer
than 15 seconds. Leaving the Steam mop in a stationary position for a longer period than recommended may cause the
build up of a pale residue. This residue can be removed by using a decalcifying product or with a few drops of vinegar.
(See troubleshooting guide)
WARNING
:
NEVER
run the Steam mop without water, NEVER direct steam at any person or animal
. Use the
Steam mop on sealed hard floor only.
When you finish cleaning, unplug Power Cord from outlet, empty the Water tank, carefully remove the Cloth pad from the
head, wind Power Cord around the Cord Wrap and store it upright in a dry area. Note that the cloth pad may be very hot.
CLEANING AND MAINTENANCE
Prior to cleaning or maintenance, isolate unit by removing cord from the power socket. Do not immerse the unit in water.
1) Microfiber Cloth pad can be machine washed in hot water and tumbled dry.
2) Wipe the steamer with a soft cloth.
The Steam mop should only be used with its own specially developed floor cloths and Filter (spare Cloth pads and Filters
are available from your retailer).
