www.Airflex5D.com
|
N
M6*30 round screw knob
4
8
A4
M5 washer
4
8
M
End cap
2
4
A5
Hanging angle
8
16
O
Sliding plate
2
4
A6
Metal clip
2
4
P
M5*18mm round head screw
4
8
A7
Projector
2
4
Q
Upper support hook
2
4
A8
Polarized Filter
2
4
Note
: Read entire instructions before starting installation and assembly of the mount.
Projector Mount Assembly
WARNING
-‐
Do not begin installation of the product until you have fully read and understood the instructions and
warnings contained in this guide.
-‐
This product should only be installed by someone with good mechanical skills, has experience with basic
building construction, and fully understands these instructions.
-‐
Make sure that the supporting surface will safely support the combined load of the equipment and all
attached hardware components.
-‐
Never exceed the maximum load capacity
-‐
Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
-‐
This product is intended for indoor use only. Use of this product outdoors could lead to product failure and
personal injury.
-‐
Tighten screws firmly, but do not overtighten to avoid stripping the screws. Overtightening the screws can
also damage the items and greatly reduce their holding.
-‐
When installing or adjusting the ceiling mount, do not use adhesives, lubricants, or oils to prevent the screws
from loosening. If you use adhesives, lubricants, or oils to prevent the screws from loosening, the casing may
crack and the projector may fail, causing serious injury and damage to the projector.
2. Attach and secure the
pan/tilt
to the
projector base plate
using
the
M8*16 hex screws
.
3. Attach the
flexible metal clip
filter holder
with the
M8 locknut.
1. Loosen the hex screws on the
pan/tilt
and remove from the
upper support hook
.
