Page 7
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Installation
The unit has been designed and tested to operate at climate class 4. Refer to the Technical Specifications of this manual or the unit rating label
for the climate class number.
The system is fully operational as soon as it leaves the factory. No addition setup is required.
CLIMATE CLASSES
Test Room Climate Class
Ambient temperature °C
Relative humidity %
0
20°C
50
1
16°C
80
2
22°C
65
3
25°C
60
4
30°C
55
5
40°C
40
6
27°C
70
7
35°C
75
N
+16°C - +32°C
-
SN
+10°C - +32°C
-
ST
+18°C - +38°C
-
T
+18°C - +43°C
-
Climate Classes
Refrigeration
Single Phase Units:
• Supplied and fi tted with an appropriately rated plug and lead, indicated as:
- 10A plug & lead fi tted
This unit must be installed in accordance with AS/NZS 60335.1
Some procedures in this manual require the power to the equipment to be turned off and
isolated. Turn the power OFF at the power point and unplug the power supply lead by the plug
body. If the power point is not readily accessible turn the equipment off at the isolation switch
or the circuit breaker in the switchboard. Attach a yellow “CAUTION-DO NOT OPERATE” tag.
This must be performed where relevant unless the procedures specify otherwise.
FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.
WARNING
Notes:
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a
hazard. Please contact Stoddart for parts and we will advise how to do this in order to avoid any electrical hazard
• The power cable should be dry and/or isolated from moisture or water
Electrical Connection
Information
Warning
SYSTEM CHARGED WITH FLAMMABLE REFRIGERANT
R600a
This unit must be serviced in accordance
with AS/NZS 1677:1998
