Airetool 5524792, Руководство по эксплуатации и обслуживанию

Страница: 2 / 16

Page 2
Safety Recommendations
Some individuals are susceptible to disorders of the hands
and arms when exposed to tasks which involve highly
Tools with clutches can stall rather than shut-off if ad-
justed over the maximum power output of the tool, or if
there is a drop in air pressure. Operator must then resist
the stall torque until the throttle is released.
Higher torqueAiretrols, inline and right angleare supplied
with a torque reaction bar designed to work with the torque
of the tool it is for, be equipped with splined torque reac-
tion mounting plates which accept torque reaction bars.
These bars can be braced against the work or other suit-
able points to absorb and relieve the operator of the torque
reaction transmitted by the tool. Tool balance arms are
also available to absprb the torque reaction of the tool while
balancing the weight of the tool for improved ergonomic
applications.
When using right angle Airetrols with lever type throttles,
be sure the throttle is positioned relative to the angle head
so that the throttle will not become wedged against an
adjacent object in the “ON” position due to the torque reac-
tion. The angle head may be repositioned with the respect
to the lever to accommodate proper location foe the task. If
tool is to be reversed, locate the throttle lever in a neutral
position that will prevent entrapment. Refer to operating
instructions for additional inform
ation.
Hearing protectors are required in high noise areas, 85
dBA or greater. The operation of other tools and equipment
in the area, reflective surfaces, process noises and reso-
nant structures can substantially contribute to, and increase
the noise level in the area. For additional information on
hearing protection, refer to Federal OSHA Regulations, 29
Code of Federal Regulations Section 1910.95, Occupa-
tional Noise Exposure, and American National Standard
Institute, ANSI S12.6 Hearing Protectors.
HEARING PROTECTION
EYE AND FACE PROTECTION
For additional information on eye and face protection, refer
to Federal OSHA Regulations, 29 Code of Federal Regula-
tions, Section 1910.133., Eye and Face Protection, and
American National Standards Institute, ANSI A87.1, Oc-
cupational and Educational Eye and Face Protection. Z87.1
is available from the American National Standards Insti-
tute, Inc., 1430 Broadway, New York, NY 10018.
For your safety and the safety of others, read and under-
stand the safety recommendations and operating instruc-
tions before operating this tool.
ALWAYS WEAR PROTECTIVE EQUIP-
MENT
Follow good machine shop practices. Rotating shafts and
moving components can entangle and enwrap, and can
result in serious injuries. Never wear long hair, loose fitting
clothes, gloves, ties or jewelry when working with or near
any power tool with an exposed rotating shaft or spindle.