Fig.3.
Canopy
Downrod Stand
Cover
Downrod
060228
TM
Page: 2 / 6
3.Thread the motor wires through the
downrod stand cover, canopy and
downrod in order.
Fig.1.
1.Turn off the electric power at the
main fuse or circuit breaker box.
4.Insert the hanger pin through the
holes in the collar and downrod.
Insert the lock pin through the hole
near the end of the hanger pin until
it snaps into its locked position.
5.Tighten the downrod screws on the
collar.
Collar
Fig.5.
2. Tighten the hanger bracket to the outlet box with two mounting screws.(
Make
sure the outlet box is securely installed so that it will be able to support
at least the fan weight.
) Attach the safety cable hook to the ceiling with the
dry wall screw and washer, and make sure the safety cable hook is covered
by the fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED
"ACCEPTABLE FOR FAN SUPPORT"!
Fig.4.
Lock Pin
Hanger Pin
Fig.5.
Fig.2.
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Washer
Safety Cable Hook
Dry Wall Screw
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Installation Steps :
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
THIS FAN MUST BE INSTALLED WITH A WALL CONTROL/SWITCH.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 21.6 lb (9.8 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
