Fig.5
Hanger Pin
Motor Wires
Collar Screw
Thread the motor wires through the
canopy, downrod stand cover and
downrod.
Installation Steps :
Hanger Pin
Lock Pin
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
THIS FAN MUST BE INSTALLED WITH A WALL CONTROL/SWITCH.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 25lb (11.4kg). Be sure the outlet box you are using is securely attached to the building structure
and can support the full weight of the fan. Failure to do so can result in serious injury.
Fig.1
Outlet Box
Hanger
Bracket
Fig.2
Turn OFF the electric power at the
main fuse or circuit breaker box.
Remove the Lock Pin and take off
the Hanger Pin.
Fig.3
Insert and tighten the two Collar
Screws. Slide Lock Pin into Hanger
Pin until it locks into position.
Fig.6
Lock Pin
Collar Screws
.
Motor Wires
Collar
Downrod
Downrod Stand
Cover
Canopy
Fig.4
Loosen the collar screws in part way.
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
Slot
Chip
Hanger Bracket
Fig.8
Fig.7
Rubber Sheath
Hanger Ball
Thread the motor wires, safety
cable and grounding wire through
the rubber sheath, then fully
cover it to the hanger ball.
Chip
Tighten the hanger bracket to the outlet
box with 2 mounting screws. (To reduce
the risk of fire, electric shock, or personal
injury, mount to the outlet box marked
"Acceptable for fan support" and use
mounting screws provided with the outlet
box.)
Note: For slope ceiling installation, make
sure that the chip of the hanger bracket
is toward the floor.
Hang the fan on Hanger Bracket, and
make sure the slot of hanger ball is
snapped into the chip of Hanger
Bracket exactly.
Note: For slope ceiling installation,
make sure the slot of hanger ball and
the chip of hanger bracket face down.
F A N C O
171120
PAGE: 5 / 8
