aireRyder F0048, Сборка и инструкция по установке

Страница: 6 / 9

PAGE: 6 / 9
Move Ground Wires (a), Outlet Box wires (b), and
Motor Wires (c) away from the center of the Hanger
Bracket. Then slide Receiver through Hanger
Bracket as shown, Antenna end first, until it is
centered. Finally, cut Motor Wires (c) to length
needed for connections.
Hang the safety cable into the safety cable hook.
Fig.11
Safety Cable Hook
Safety
Cable
Fig.12
Canopy Screw
Key Hole
Slot
Hanger Bracket
Canopy
Decorative Cap
Fig.10
Hanger
Bracket
Hanger
Ball
Receiver
1.
5. 6.
7.
2.
4. 3.
Antenna:
DO NOT CUT
OR SPLICE
Connect wires:
1) The white (neutral) wire from motor to the white (neutral)
"TO MOTOR N" wire from Receiver with a wire connector.
2) The black (hot) wire from motor to the black (hot)
"TO MOTOR L" wire from Receiver with a wire connector.
3) The blue wire from motor to the blue for "Main Light L" wire
from Receiver with a wire connector.
4) The organge wire from motor to the organge for "Accent
Light L" wire from Receiver with a wire connector.
5) The white (neutral) wire from Outlet Box to the white "AC in
N" wire from Receiver with a wire connector.
6) The black (hot) wire from Outlet Box to the black "AC in L"
wire from Receiver with a wire connector.
7) The ground wire from Outlet Box to the green ground wire
from the Hanger Ball and the green ground wire from the
Hanger Bracket with a wire connector.
Make sure all of wire connectors are connected firmly.
*** Put all wire connectors and wires carefully up into the
Outlet Box.
There is a code switch in the transmitter and
receiver. This "DIP Switch" is a 4 key units
(Fig.8). All keys were set at "ON" position in
the beginning. Set the keys to a different
code. Make sure the same numbered keys
are switched "ON" for both DIP switches
(Fig.8a). If the remote controlled fans are
installed than one or the frequency is
interfered, the fan may function abnormally.
Code example:
1-ON 2-OFF 3-ON 4-OFF on both DIP
Switches.
Note: If you have two ceiling fans with 2
remote control units, set 2 different
codes for each set of transmitter / Receiver.
Fig. 8
Antenna
DIP Switch
Transmitter
Receiver
Fig.8a
Loose canopy screw
and do not remove it ,
push the canopy
upwards to cover
hanger bracket by
inserting canopy screw
into key hole slot, then
rotate the canopy till it
fixed on the hanger
bracket. finally, Attach
the decorative cap to
canopy, rotate it
clockwise until tight.
Antenna
Receiver
Hanger
Bracket
a.
b.
c.
Fig.9
181128