Airdog A3SPBT403, Руководство по установке, Страница: 25 / 28

25
PureFlow
®
Technologies, Inc.
AirDog
®
FPII-150 Detroit Series 60 2003-09
Section 9 Initial Start Up
SECTION 9: INITIAL START UP PROCEDURE
The AirDog
®
is a self priming system. However, to prevent damage to a dry seal and reduce the life
expectancy of the system, it is suggested to pre-fill the water separator/pre-filter with diesel fuel to
the bottom of the “NUT PLATE”.
r
9-1. Rub CLEAN diesel fuel or oil on filter seals before installing to ensure a proper seal.
r
9-2. Pre-fill the water separator/pre-filter with diesel fuel up to the bottom of the nut plate.
r
9-3. Turn the starter key to the on/run position.
r
9-4. The AirDog
®
should now be running and pumping fuel, bleed the fuel line to the engine by
loosening the fuel line connection at the engine fitting. As soon as the line is purged of air
and pure fuel is observed, properly tighten the fuel fitting.
NOTE: Put a rag or shop towel over and around the fitting to prevent fuel splatter or
spray. Catch all spilled fuel and dispose of properly. Wear safety glasses.
r
9-5. Start the engine.
RECHECK ALL FUEL FITTINGS FOR LEAKAGE AND PROPER TORQUE.
BE SURE ALL FUEL LINES ARE PROPERLY ROUTED TO PROTECT
FROM EXCESSIVE HEAT AND SECURED TO PROTECT FROM CHAFING
AND ABRASION. RECHECK ALL ELECTRICAL LINES AND SECURE AS
NECESSARY.