Aircraft XAircraft X450, Инструкция по эксплуатации

Страница: 20 / 22

地面摇杆操作测试后，进行传感器工作状态测试。
1 拔出飞行模式选择通道 的连接线。
2 将遥控器油门收到最小后打开遥控器开关。
3 X450 接通电源。
4 半蹲姿势，左手抓紧 X450 的底部，举到前上方，高度高于头顶。
5 右手轻推油门至 20% 的杆量。
6 尝试使用左手使飞行器前、后、左、右倾斜，感觉飞行器是否阻止您使
飞行器倾斜。
7 如果飞行器没有阻止您使它倾斜，则将油门收到最小，断开 X450 电源，
重新检查电路安装（如 AHRS 的安装方向是否正确，连接线是否接好）
后再次测试。
8 如果飞行器的反应正确，将油门推最小，断开 X450 的电源，就可以进行
首次试飞了。
（默认为 Input5 ）
姿态传感器工作状态测试 AHRS Function Test
After X650 stick function test on ground now it goes sensor test.
1 Unplug Flight Mode channel signal cable (default Input 5).
2 Throttle down to lowest then start RC.
3 Power on X450.
4 Squat and grasp the bottom side of X450 to lift it higher than your head.
5 Apply throttle slowly to 20%.
6 Try to bank the aircraft forwards, backwards, left side and right side and
feel it whether aircraft has stopped your moving.
7 If no resistance, throttle down to lowest and power off X450.Check if
electronic parts installs properly.(Like AHRS installation orientation or
good connection).Then test again.
8 If aircraft reacts perfect, throttle down to lowest and power off
X450.Now you can start your first fly and enjoy it.
测试时请注意安全， 避免被螺旋桨击中。
Pay attention to rotating blades from getting hurt .
注意 CAUTION
19
www
.
xaircraft.com