Figure 5
5
Attach the wings, engines and saddle tanks as shown in Figure 6.
A
Attach the centre section to the fuselage. Make sure it is
correctly aligned before the adhesive cures.
B
Attach the outer wings which were prepared in step 2 B 2 to
the centre section.
C
Clip No.1 engine assembly to the front of the nacelle firewall
- do not attach it at this time. Align the engine and the No.1
saddle tank and attach the saddle tank to the wing. Do this
procedure again for the other three engines and saddle tanks.
Allow the adhesive to cure, then remove the four engine
assemblies.
D
Attach the engines permanently and allow the adhesive to
cure..
Figure 6
SADDLE
TANKS
CENTRE
SECTION
ENGINE
ASSEMBLIES
No.4
No.2
No.3
No.1
SADDLE
TANKS
FUSELAGE
PLUGS
