INSTALLATION
PRESENTATION
SPARE PARTS
Electrical heaters «
ARMAGNAC
» are delivered ready for installation with a 3 phases 400V
power supply (For single phase 230V power supply an order for special unit must be placed).
As standard supply, these units are delivered with :
-
Single phase fan motor 230V – 1000 RPM
-
Armed electrical coil 1000 and/or 2000 W
-
Power
relay
-
Safety thermostat (Limit)
-
Automatic
thermostat
-
Timer
thermostat
-
On/Off switch and « On » light indicator
-
Connection
terminal
Then these units are « Plug and Play » type.
IMPORTANT
Regulation and fan motor are single phase 230V energized, consequently neutral must be
supplied in the alimentation cable.
Check that the electrical supply comply with electrical heater nominal power. Connect the
supply cable to the connection terminal.
Your electrical heater Armagnac is ready for use.
The electrical heater should not be fitted too high on the wall in order to keep a certain hot air
influence over the area to be treated. Electrical heaters Armagnac have front adjustable
louvers.
Adjust the louvers according to the height of the installation and the area to be treated.
For the same power need, the comfort (hot air repartition) will be better by using numerous
units (ex. for 96 KW need, 8 units 12KW are more comfortable than 4 units 24KW).
ARMAGNAC 1
From 6 to 12 kW – only one heating pace as standard.
Optional ARMAGNAC 1 power 9 and 12 kW can be supplied with 2
heating paces :
9 kW = 6 + 3 kW
12 kW = 6 + 6 kW
When delivered with 2 heating paces option, the electrical connection
must be done similar to the ARMAGNAC 2 wiring diagram.
ARMAGNAC 2
From 15 to 24 kW – only two heating paces as standard :
15 kW = 9 + 6 kW
18 kW = 12 + 6 kW
21 kW = 12 + 9 kW
24 kW = 12 + 12 kW
In any case of parts replacement, please use the spare list attached. Use only parts
delivered by the manufacturer.
