© Copyright –
AirApp Power Tools GmbH • Siemensstr. 9 – 11 • 40885 Ratingen
3
Maintenance
When servicing the orbital sander, observe the environmental regulations under local law.
To achieve a longer lifetime, the manufacturer recommends annual professional maintenance by trained, qualified
personnel of your service partner.
If you have any questions, please contact the manufacturer.
Lubrication of the motor
Orbital sanders SE1, SE2, SE4 and SE9 have oil-free motors and must not be lubricated with oil.
Disconnect all other orbital sanders from the compressed air in order to prevent accidental activation.
The motor requires lubrication to ensure proper functioning of the motor component group.
1. Use only mist lubricant approved by the manufacturer
2. Clean the air inlet of dirt before oiling
3. Insert mist lubricant (approx. 2 – 3 drops) into the air inlet, while keeping the trigger pressed
4. Allow the machine to idle briefly at the lowest power setting
Attention!
Maintenance of the orbital sanders may only be carried out by qualified personnel.
Repairs should only be carried out by the service partner of the manufacturer.
Disposal
When disposing of the device, comply with applicable local legislation. Remember that incorrect disposing of lubri-
cants causes environmental damage.
We accept no liability or warranty for damage or injuries resulting from improper use or misuse or failure to
comply with the safety information.
The device must only be used for the applications described.
Any other use is prohibited.
