Installation Instructions. Read Me!
I
DISCONNECT NEGATIVE (-) BATTERY CABLE
II
Remove Factory Air Box Lid
a)
Loosen the factory intake tube clamp at the air box lid
using a flat head screwdriver.
Refer to Fig #1
1991-1995 Models Only:
b)
Disconnect the vacuum hose located on the driver side
rear of the factory air box. Next disconnect the small
vacuum line where it attaches to the intake manifold. Be
careful with the plastic line as it is fragile. It is only
moved to enable the install.
Refer to Fig #1
c)
Disconnect the breather hose from the passenger side of
the factory air box lid.
Refer to Fig #1
d)
Unclip the factory air box lid and remove from engine
compartment.
See Fig #1
III
Assemble the Airaid Intake System
a)
Mount the black plastic adapter tube onto the Airaid
Cool Air Dam and fasten using the two 1/4-20 button
head bolts and two lock washers provided.
See Fig #2
b)
Assemble the two Airaid Cool Air Dam panels using the
small screws, nuts, and washers provided.
See Fig #2
IV
Install the Airaid Intake System
a)
Position the Airaid Cool Air Dam in place of the original
factory air box lid and snap into place.
See Fig #3
b)
Connect the factory tube onto the Airaid plastic tube
using the factory hose clamp.
Refer to Fig #3
1991-1995 Models Only:
c)
Reattach the small vacuum line to the factory locations,
including the manifold. Replace the short factory hose
located on the plastic factory tube, with the longer ½”x
7” hose and secure on the intake tube nipple using the
two #16 black Speed clamps included.
Refer to Fig #3

d)
Reattach the breather hose to the Airaid plastic adapter
tube.
Refer to Fig #3
1996-2001 Models Only:
e)
Plug the remaining nipple on the driver’s side of the
Airaid tube with the black rubber cap provided.
Refer
to Fig #4
f)
Mount the Airaid Premium Filter to the plastic adapter
inside the air dam.
Refer to Fig #3
g)
Press the provided weather seal onto the top rim of the
Airaid system.
Refer to Fig #3 (Hint: Start at a corner
of the air dam for ease of installation.)
V
Finishing Up
a)
Inspect overall work and check hood clearance.
b)
Ensure that no foreign objects are in the intake path!
c)
Re-connect negative battery cable.
Vacuum line
Breather hose
Fig#1
Fig#2
Small Vacuum Line
Breather Hose
Fig#3
To Nipple on tube
91- 95: attach provided 7”
hose to plastic tube.
(Shown)
Late 96-01: Plug nipple on
plastic intake tube with
rubber cap provided.
(Not Shown)
Fig#4
Rev. 03/08/07
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
www.airaid.com
