AIR-I30370
REV 9/19/18
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are
not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing,
contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water.
WATER INGESTION IS THE DRIVERS RESPONSIBILITY!
The air filter is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
702-466 Airaid SynthaMax Dry Media - Black
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common
non-petroleum all-purpose household cleaner
and water. Simple Green®, Formula 409® or
equivalent works great. Apply cleaner to outside of
air filter and allow to soak. Then flush filter clean
from the inside out with a garden hose and repeat
steps if necessary. Do not apply high pressure
water or air to clean filter. Allow filter to air dry
and reinstall.
Airaid. 1455 Citrus St., P.O. Box 1329, Riverside, CA. 92502 1-800-498-6951 [email protected] www.airaid.com
For your Oiled media filter we offer the
Airaid Tune Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
26.
Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance!
Reconnect the negative battery cable!
Continued...
22. Install the intake tube assembly into the coupler hose
at the filter adapter and then into the coupler hose at the
throttle body. Adjust the tube for best fit and then secure
with the provided hose clamps.
23. Reconnect the inlet air temperature sensor electrical
connection.
24. Install the provided quick disconnect fitting into
the provided crank case vent hose and secure with the
provided hose clamp.
25. Install the crank case vent hose assembly onto the
fitting installed into the intake tube and then connect the
quick disconnect fitting into the factory connector as
shown.