Charging the Helicopter
Push the cover of the controller into arrow direction to
get out the charging lead. Turn off the Helicopter and
connect the charging lead with the charging socket of
the model.
The connector slides in easily
– never
push with pressure –
ALWAYS
make sure that the
direction is right!
When connected, turn on the controller; the green LED
will indicate the charging period of about 15 to 25
minutes.
Switch of the Controller when charging is finished, else
the batteries will drain!
Charging the model needs more juice than flying. When
the green LED is only blinking for some seconds, the
batteries are too low to charge and must be replaced!
First Flight
Switch “ON” the Controller and also the helicopter.
Move the Throttle to the top once and return to bottom position. This connects the Helicopter with the controller! Make
sure using different bands (3: A, B, C) when flying with 2 or 3 models at the same time. Now the model is ready to
start!
When the Battery of the model becomes weak, the
helicopter will reduce the motor speed with short stops in
between. Time to land and to recharge! Do not use the
model until fully empty – this damages the battery.
Recharge the model before you store it
and
ALWAYS
power off after use
– else the battery will be damaged!
How to control
The Helicopter is moving according to the drawing
