Air Weigh QuickLoad, Руководство по установке, Страница: 13 / 20

11
2. Tighten both nuts and use a torque wrench to torque to 60
ft-lbs.
3. Verify the A/D reading using the display in the cab (start the
ignition to power on the display), or the delection sensor
test box. If the reading is within range (750-1250), continue
to instructions for the
Final Sensor Torque . If the reading
is not within range, follow the instructions to adjust the A/D
readings below.
Adjusting the A/D Reading
If the A/D reading is above 1250, follow these instructions:
1. Loosen the nuts on both ends of the sensor
2. At the plastic nut where the cable enters the sensor,
exert DOWNWARD
pressure with your ingers until the
A/D reading is between 750 and 1250. Continue to apply
pressure to maintain the desired A/D reading during the
torque procedures in step 3.
3. Tighten the nut on the cable end of the sensor and torque to
60 ft/lbs.
Continue to apply pressure with your inger to
the plastic nut during torquing in order to maintain the
desired A/D reading
. If the A/D readings are still within the
750 to 1250 range after the nuts on both sides of the sensor
have been torque to 60 ft/lbs., continue to instructions for
the
Final Sensor Torque .