©
2020 Air Techniques, Inc. August 2021
P/N J1151 Rev. B
Computer Setup.
Set up the computer system according to the manufactur-
er's recommendations. Make sure that the computer meets all requirements
listed in the manual. Before connecting the ScanX to your computer/network
or attempting to use it for the first time, run the Setup program on the ScanX
Software and Manuals Disk included with the ScanX.
USB Driver Setup.
When using USB, windows should automatically find the
USB drivers once the ScanX and computer are turned on.
Initial start-up.
Refer to the manual section 8 for detailed procedures to
register and configure ScanX via VistaConfig. This allows ScanX to be oper-
ated using USB, Ethernet or Wi-Fi connections. Once properly registered and
configured, ScanX is ready for use.
Electrical connection
. Perform the following steps to connect the ScanX
to the facility Mains. Before initial start-up, check the supply voltage with the
voltage information on the model identification plate (see also “4 Technical
Data” in the manual.
1. Remove the cover from the rear of the device.
2. Connect the 24VDC Power Supply Adapter Output Connection Cable to
the Inlet Power Jack (item 4) located on ScanX rear panel as shown by
the ScanX Rear Panel Connection Ports illustration.
3. Connect the 24VDC Power Supply Adapter to the Mains outlet using the
Mains Cable.
4.
Verify that the On/Off switch illuminates amber denoting ScanX is in the
standby mode.
5.
Replace and secure the rear cover making sure that it is correctly fitted.
Switch the scanner from Standby to ON by
pressing the On/Off switch ( ) located on
the top of the scanner. Verify that the On/Off
switch illuminates, signifying ScanX is on.
On/off
switch
Touch
screen
