4.
Using a 4 mm hex key, remove the (3) bolts and washers securing the inlet manifold to the motor inlet.
5.
Using a 9/16 inch wrench, remove the (3) bolts and washers securing the motor to the bottom chassis.
Note:
Use extra caution not to damage the grounding lug for the Air Water Separator.
6.
Slide the motor out from the unit chassis.
7.
Insert the replacement motor, aligning the (3) mounting holes to the holes in the bottom chassis.
8.
Insert the (3) bolts and washers to secure the motor to the bottom chassis.
Note:
The Air Water Separator grounding lug should be between the washer and bolt head.
Do not overtighten the bolts.
9.
Insert and tighten the (3) bolts securing the inlet manifold to the motor inlet.
10. Re-connect the brown “MOTOR” and orange “MOTOR FAN” circular connectors to the back of the
electrical box by tightening the locking ring closest to the electrical box on each connector.
11. Reconnect any hoses which were disconnected from the motor exhaust port.
12. Turn power to the device ON.
Motor Reshipment Packaging
Use the original packing material that provides adequate coverage and protection of the motor during shipment.
Electrical Box
Inlet Manifold
Air Water
Separator
Motor Inlet
4 mm Hex Head
Bolts and Washers
MOJAVE Motor
Assembly
9/16 - Inch Securing
Bolts and Washers
Ground
Cable
