Air Lift Wireles One 25870, Руководство по установке

Страница: 11 / 20

9 MN-751
WirelessONE
“T-Fitting” to Springs:
1. Cut a section of the 1/4” DOT air line (D) provided to go from “T-Fitting” (F) to Left
and Right air springs.
2. Insert one side of air line (D) into “T-Fitting” (F) and the other into the air springs.
HOW TO REMOVE AND INSTALL THE BATTERIES IN THE
REMOTE CONTROL UNIT
1.
To remove the two CR2032 batteries use a small flat screw driver to seperate the two
halves of the key fob by prying at the internal clip locations shown in figure 7.
2. Stack the two CR2032 batteries Positive to Negative inside the rear cover.
3. Clip the front cover and circuit board into the rear cover (fig. 8).
Internal Clips Internal Clips
fig. 7
M2
M1
The case must be
aligned (as shown)
when assembling
with batteries .
fig. 8
This is the
negative side
for battery
replacement .