Air Lift SureSET 25004, Руководство по установке

Страница: 11 / 16

9
MN-594
SureSet
SETTING THE DIGITAL CONTROLLER
When the system is started, the pressure will automatically set at the minimum pressure of
5 p.s.i. The system will not allow you to set your pressure below this point.
1. Press the plus or minus button on the controller to add or exhaust air from the air bags
( fi g. 12).
Only one side of the system can be controlled at a time.
2. Once the pressure is changed, a check mark will appear on the screen. After 10 seconds
has elapsed, the check mark will disappear and the pressure will then be set in memory
fi g. 12).
The system will automatically maintain the set p.s.i. in the air bags until the air pressure
setting has been changed.
THINGS YOU NEED TO KNOW
1. You can only air up one bag or side at a time. This is due to the fact that only three
solenoids are utilized in the system so that the manifold can be smaller and more
economical.
2. Once you have selected a pressure setting, you must wait for the check mark on the
SureSet display screen to disappear before the setting will be permanently stored into
the memory. Failure to wait or turning the vehicle off will cause the previous setting to
remain stored.
3. The SureSet system will maintain your pressure setting within a range of plus or minus 3
psi. This is necessary so that the SureSet system will not continue to make adjustments
while the vehicle is being driven.
CHECKING THE SYSTEM
1. Inspect all air line connections with a solution of 1/5 dish soap to 4/5 water. Should a
leak be detected in a push-lock- fi tting, reinstall the air line to the fi tting. Make sure the
air line is cut off squarely and that the air line is completely pushed into the fi tting.
2. If the compressor or the solenoid fails to function, check the 20 AMP fuse and ground
connection. Repair and replace as necessary.
+
–
+
–
U
5
U5
U
L
9
U
R
9
fi g. 12
NOTE
NOTE