Technical Support
1-800-248-0892
IMPORTANT: Always keep safety in mind when
working on your vehicle. Completely read these
instructions before installing the kit.
I. Preparing the Vehicle
1. Jack the vehicle up and support the body on jackstands.
2. Remove the rear wheels (Figure 1).
II. Strut Removal
1. Remove the lower strut mounting bolt and retain for later use
(Figure 2).
2. Remove the two nuts from the sides of the upper strut mount.
NOTE: These are located behind the back-seats on the
inside of the vehicle (Figure 3).
3. Remove the strut assembly from the vehicle (Figure 4).
III. Installing the Upper Strut Mount
1. Using a spring compressor for safety, remove the center nut
from the upper strut mount. Remove the upper strut mount,
rubber bushing and flat washer from the top of the O.E.M. strut
and retain for use with the front kit (75570).
2. Place the upper strut mount (B) with the counter-sunk side
downwards, in place where the O.E.M. mount was previously
located.
3. Place the counter-sunk bolts (E) into the holes and place the
lock washers (F) and hex nuts (G) onto the bolts on the upper
strut tower from the inside of the vehicle . Tighten securely.
Figure 1
Figure 2
Figure 3
Figure 4
Hardware
Item P/N Description
Qty.
35059 Accord Strut Assembly
2
07076 Upper Bracket
2
17197 3/8” x 1” Counter Sunk Bolt
4
18427 3/8” Lock Washer
4
18430 3/8” Hex Nut
4
13002 Rubber Bushing
2
09333 Rubber Spacer
2
26372-070
Aluminum Spacer
4
10069 Heim Joint
2
18246 Jam Nut
2
A
B
E
F
G
H
I
J
K
L
M
