3.
Line up the slot in the reflector plate with lances on the inside
of housing. Insert included #8 screws through reflector plate
slot and into housing lances. Tighten both screws until the grill
fits snugly to the ceiling. DO NOT OVER TIGHTEN (
Figure 12)
.
CAUTION:
FAILURE TO SECURE THE GRILL MAY RESULT
IN A RATTLING OR HUMMING NOISE.
4.
Install a 100 watt maximum, type A19 medium base
incandescent bulb (not included) and reinstall the lens into
the grill (
Figure 12)
.
5.
Restore power and test your installation.
www.airkinglimited.com
210572092 Rev. A 8-05
4 of 12
Figure 11
SECTION 7
Use and Care
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
1.
Cleaning the Grill:
Remove grill and use a mild detergent,
such as dishwashing liquid, and dry with a soft cloth. NEVER
USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry grill before reinstalling. Refer to instructions
in
Section 6
Completing the Installation
, to reinstall grill.
2.
Cleaning the Fan Assembly:
Unplug the motor cord and light
cord from receptacles and loosen the venturi screw to remove
the venturi from the unit. Wipe all parts with a dry cloth or
gently vacuum the fan. NEVER IMMERSE ELECTRICAL PARTS
IN WATER. Refer to instructions in
Section 6
Completing the
Installation
, to reinstall venturi.
CAUTION:
ALLOW BULB TO COOL BEFORE REPLACING
3.
Changing the Light Bulb:
Disconnect power to the unit.
Remove the light lens by squeezing at the tabs and pulling
down (
Figure 13)
. Remove light bulb and refer to instructions
in
Section 6
Completing the Installation
, to complete the light
bulb change and installation of light lens.
Figure 13
Tab
Figure 12
Tab
Lens
Grill
Reflector
Lances
#8 Screws
