RIGHT
SPIN
LEFT
SPIN
Left joystick forward
Right joystick back
Left joystick back
Right joystick forward
By pushing the joystick on the Controller, you can make your Wall Climber spin around on the spot.
Push the LEFT joystick forward and the RIGHT joystick
backward to make the vehicle spin clockwise.
Push the LEFT joystick backward and the RIGHT joystick
forward to make the vehicle spin counter clockwise.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications not expressly approved by the party responsible for its compliance could void the user’s
authority to operate the equipment.
TROUBLE SHOOTING
FCC REQUIREMENTS
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master, Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221, USA
Spin Master Toys Far East Limited, Rm #1113, 11/F,
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK
Spin Master France SAS, 36 rue de Silly, 92100 Boulogne, France
North American Consumer Information
Phone: 1-800-622-8339
www.spinmaster.com
Air Hogs TM and Zero Gravity TM are trademarks of
Spin Master Ltd.
© 2004 Spin Master Ltd. All rights reserved.
Manufactured for and distributed by Spin Master Ltd.
Conforms to safety standards ASTM F963-03,
EN71 Regulatory Requirements. Products and colors
may vary. Please retain this information for future reference.
MADE IN CHINA.
Asst. #14125. Item #14126, #14127.
REV 0 U.S. English
PROBLEM
Vehicle will not start.
Vehicle does not climb.
Vehicle does not drive straight.
Vehicle slips climbing the walls.
Even with ramp, vehicle can’t
transition over trim.
Vehicle falls off the wall.
Vehicle will not climb walls.
SOLUTION
1. Power switch is off. Turn on. 2. Controller battery is installed with incorrect polarity. Check the
(+) and (-) markings to make sure the battery is properly aligned. 3. Batteries are drained.
Charge batteries and/or install new batteries.
1. Over current protection is engaged. Turn vehicle off for 30 seconds then restart.
1. Make sure that the toggle switch on front of vehicle is in the correct position. 2. Make sure
surface is clean of dirt/dust. 3. Make sure surface is neither too rough or too smooth.
1. Clean the tires with a damp rag. 2. Fold up the fabric skirts for a better seal prior to use.
1. Make sure the ramp is fitted tight to the wall. Try using hard cardboard from around the
house if insert is damaged.
1. Make sure to discharge and then charge again for 4 hours. 2. Clean tires and make sure your
wall and floor are also clean. 3. Check the fabric skirts for damage. If they have been pulled
loose, tape them back on with flexible tape.
1. Suction jammed. CALL 1-800-622-8339.
TM
Contains NiCd battery
pack. Battery pack
must be recycled or
disposed of properly.
NOTE: On the wall the vehicle may spin toward the ground.
IMPORTANT BATTERY IMFORMATION
• Battery installation should be performed by an adult.
• Be careful to install batteries with the correct polarity as
indicated.
• Do not mix new and old batteries.
• Do not mix alkaline, standard, rechargeable or different types
of batteries.
• Different types of batteries or new and used batteries are not
to be mixed.
• Exhausted batteries are not to be removed from the toy.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are only to be charged under adult
supervision (if removable).
• Rechargeable batteries are to be removed from the toy before
being charged (if removable).
• Only batteries of the same or equivalent type as
recommended are to be used.
• The supply terminals are not to be short-circuited.
• Do not dispose of batteries in fire. Battery may explode or leak.
• Power rating: Input AC120V, 60Hz, 8W. Output DC7 .5V,
400mA.
• The provided charger is not a toy. Adult use only.
• Charge your RC Wall Climber only with the provided charger.
• Do not attempt to short circuit the charging port and
charging adapter.
• Your RC Wall Climber should be charged every 6 months of
prolonged storage condition.
• Never recharge a fully charged battery. Always discharge the
battery before charging.