HOW TO INSTALL YOUR BATTERIES
HOW TO CHARGE YOUR SHARPSHOOTER™
BATTERY INSTALLATION – CONTROLLER/CHARGER
1.
Open the battery door with a screwdriver (pic.1).
2.
If used batteries are present, remove these batteries from the unit by pulling up on one end of each
battery.
3.
Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment (pic.2).
4.
Replace battery door securely (pic.3).
5.
Check your local laws and regulations for correct recycling and/or battery disposal.
LOADING MISSILES
Things to remember:
pic.1
pic.1
pic.1
pic.2
pic.2
pic.2
Turn controller off and lift
up the cover. Take out the
charging wire.
STEP ONE
STEP TWO
STEP THREE
STEP FOUR
OFF
ON
OFF
ON
OFF
ON
pic.3
pic.3
pic.3
Turn the controller to the CHG
position. The charge LED will flash.
Once completed both charge and
power indicators will flash concurrently.
Pull the charge plug out of the
helicopter and store in controller.
Insert the charge plug into
the charge socket located on
the side of the helicopter.
1. Align missile with launch tube.
2. Make sure missile key is aligned with launch tube keyway.
3. Slide missile into launch tube until a click is heard or felt.
The missile should latch into place.
4. Repeat for other side.
1. Aim helicopter at target.
2. Press the fire button once to release the first missile.
3. After a couple of seconds, press the fire button again to release
the second missile.
LAUNCHING MISSILES
Missile
Key
Launch Tube
Keyway
Launch
Tube
Firing Button
WARNING:
Do not aim at eyes or face.
Turn the helicopter OFF using
the ON/OFF switch on the
underside.
Front of Heli
Front of Heli
Front of Heli
2
1. The Sharpshooter™ will have around 4-5 minutes of flight time after a 30-40 minute charge.
2. Before you recharge the battery, wait 10-15 minutes to let the battery cool down.
