www.airdryclotheslines.com.au
4
Step 6:
Attaching the twin fold unit
•
2 x 110mm bolts
•
2 x 90mm bolts
•
4 x nuts
•
4 x washers
•
New long spreader bar (Step 4)
Make sure that the wall side sticker is facing away from
you and place it up to the first post. Take the 110mm bolt
with a washer and insert it through the top hole of the
arm assembly and through the post. Lift one end of the
long spreader bar and place it onto the bolt and secure
with a nut. Take the 90mm bolt with the washer, place it
through the bottom hole on the arm assembly then
through the post and secure with a nut.
Repeat with the opposite arm assembly. Measure the distance between the top of the posts and the
bottom of the post and make sure this is the same and parallel. Adjust if needed.
Step 7:
Assembling the front bars
Inner frame:
Place the small spreaders
on the ground. Insert the 2 spreaders
into each end of the joiner to make
one long bar. Place each end of the bar
into the ends of the 750 inner frame
arms.
Outer Frame:
Place the large
spreaders on the ground. Insert the 2
spreaders into each end of the joiner
to make one long bar. Place each end
of the bar into the ends of the 1500
outer frame arms.
