Air 802 AP25N01, Руководство пользователя, Страница: 77 / 100

AP25N01 User Manual
53
•
Make sure your browser has Java, JavaScript, or ActiveX enabled. If you are
using Internet Explorer, click Refresh to be sure the Java applet is loaded.
•
If you are configuring more than one access point using the same PC, you may
encounter an Address Resolution Protocol (ARP) issue. This is due to the access
points having the same default IP address but different MAC addresses. If this is
the case, try and clear the ARP table of your PC through a DOS command (click
Start, click Run, enter CMD in the dialog box, enter arp –d at the prompt and
press Enter). Alternatively, you can clear the issue by restarting your PC.
•
Try quitting the browser and launching it again.
•
If you still can’t gain entry, try a hard reset by pressing the reset switch (with
power on) for 10 seconds. The unit takes one to two minutes to fully reload the
default configuration settings. This will reset the IP address back to
192.168.2.254 if it had been changed.
Configuration Changes Not Saved
If the AP does not save changes you have made to the Web Configuration Interface,
check the following:
•
When entering configuration settings, be sure to click Apply Settings before
moving to another menu or tab, or your changes will be lost.
•
Click Refresh or Reload in the Web browser. The changes may have been made
but the Web browser is caching the old information.
No Internet Access ???
Wireless (Bridge - AP Mode)
If you are unable to access the Internet through the AP25N01:
•
Verify that you have established a wireless connection between your computer
and the AP25N01.
•
Unless you are using static IP addresses in your network, verify whether you
have been provided an IP address. To do this go click Start , click Run , Type
"CMD" in the dialog box and press Enter , type "ipconfig" at the prompt and press
Enter . Scroll up as necessary to see if a valid IP address has been provided.
Note: Recent versions of Windows and MacOS will generate and assign an IP
address in the range of 169.254.x.x if the computer cannot reach a DHCP server.
If the listed IP address is in this range, you have not been assigned an IP
address by the DHCP Server. This indicates a likely issue in the configuration or
cabling to an upstream device providing DHCP function.
•
If you have enabled encryption (security), access the AP25N01 via the wired
Ethernet interface (unless the operating mode is Router). Disable security and re-
check to see if you have connectivity. If you do have connectivity, encryption was
not properly established between your computer and the AP25N01.