IX-MV7-HB, IX-MV7-HW, IX-MV7-B, IX-MV7-W
(Master Station)
Issue Date: Oct. 2018 FK2461 B P1018 MQ 60409
Introduction
• Read this manual before installation and connection.
Read the "Setting Manual" and "Operation Manual". The manuals can be downloaded from our
homepage at "https://www.aiphone.net/product/support/" free of charge. (The manuals will be
available from 9 November 2018 onwards.)
• After completing installation and connection, program the system according to the “Setting Manual”.
The system cannot operate unless it is programmed.
• After performing installation, review with the customer how to operate system. Leave
documentation accompanying the Master Station with the customer.
Perform installation and connection only after gaining sufficient understanding of the
system and this manual.
The illustrations used in this manual may differ from the actual stations.
Example of System Configuration
LAN
PoE switch
(third party)
PC (third party)
PoE switch
(third party)
PoE switch
(third party)
Network video
recorder
(third party)
Network camera
(third party)
IX-DVF
IX-DA
IX-MV
PoE switch
(third party)
PoE switch
(third party)
IXW-MA
PoE switch
(third party)
IX-SS-2G
IX-RS-B
IX-MV7-HB
PoE switch
(third party)
Status Indicator
Refer to "IX-MV7-* Operation Manual" for additional indicators not listed below.
: Lit : Off
Status (pattern)
Meaning
Orange
flashing
Normal flashing
0.75 sec
0.75 sec
Booting
Rapid flashing
0.25 sec
0.25 sec
Device error,
Startup error
Long interval flashing
0.5 sec
4 sec
Communication
failure, Line
supervision and
device check error
Long irregular flashing
1
sec
0.25
sec
0.25
sec
0.25
sec
0.25
sec
0.25
sec
Firmware version
updating
Short irregular flashing
1
sec
0.25
sec
0.25
sec
0.25
sec
Initializing
Blue light
Standby (Depends
on setting)
Part Names and Accessories
IX-MV7-HW, IX-MV7-HB
IX-MV7-W, IX-MV7-B
Included accessories
Product
warranty
(Japanese) ×1
Notice
(IX Manuals and
Software) ×1
Desktop stand ×1
(Shape depends on
presence of handset)
Mounting
bracket ×1
(attached to the unit)
Mounting-bracket
screws ×4
Cable tie ×1
Wall-mounting
wood screws ×4
Desktop-stand
screws ×4
Desktop-stand
fastening screw ×1
Option
connector ×1
Front view
Side view
Back view
Front view
Side view
Back view
Camera angle adjustment lever
LAN port
Low-voltage connection terminal
Option connector terminal
LAN port
Low-voltage connection terminal
Option connector terminal
MAC address
Camera angle adjustment lever
MAC address
Reset button *
microSD
TM
card slot *
3.5 mm jack
Reset button *
microSD
TM
card slot *
3.5 mm jack
Microphone
Home button
Touchscreen LCD
* Accessible when terminal cover is
opened
Speaker
Handset
Camera privacy cover lever (on top)
Status indicator
(Orange/Blue)
Camera
Status indicator
(Orange/Blue)
Camera
Microphone
Home button
Touchscreen LCD
Speaker
* Accessible when terminal cover is
opened
Camera privacy cover lever (on top)
Desktop-stand fastening screw hole
Desktop-stand fastening screw hole
Installation Manual ×2
(English, Japanese)
Warning
Negligence could result in death or serious injury.
Do not disassemble or modify the
device.
May cause fire or electrical shock.
Do not, under any circumstances,
open up the device.
Voltage within some internal
components may cause electrical
shock.
The device is not designed to
explosion-proof specifications.
Do not install or use in an oxygen
room or other such locations
filled with volatile gases.
May cause fire or explosion.
Caution
Negligence could result in injury to people or damage to
property.
Do not install or connect the
device with the power on.
May cause electrical shock or
malfunction.
Do not turn on power without first
checking to make sure the wiring
is correct and there are no
improperly terminated wires.
May cause fire or electrical shock.
Install the device in a position
where it will not easily be brushed
against by somebody's shoulder,
etc.
Failure to do so could result in injury.
Do not install the unit in location
subject to frequent vibration or
impact.
It may fall or tip over, resulting in
damage to the unit or personal
injury.
For testing and verification of
chime volume and call tone
volume, do not hold the handset
close to your ear.
May cause harm to the ear if a
sudden loud noise is emitted.
Do not put your ear close to the
speaker when using the device.
May cause harm to the ear if a
sudden loud noise is emitted.
General Precautions
• If the device is installed in a dark place, but positioned in a direction where subjects will be back-lit by a
bright light, it may affect the clarity of the image shown on the liquid crystal display.
• Install low-voltage lines at least 30cm (11") away from high-voltage lines (AC100V, 200V), especially inverter
air conditioner wiring. Failure to do so may result in interference or malfunction.
• When installing or using the device, give consideration to the privacy rights of subjects, as it is the
responsibility of the system owner to post signs or warnings in accordance with local ordinances.
• Talk within 30cm (11") or less from the unit. If you stand too far away, it may be difficult for the other person
to hear the communication.
Notice
• The illustrations and images used in this manual may differ from the actual items.
• If the device is used in areas where there are business-use wireless devices such as a transceiver or mobile
phones, it may cause malfunction.
• If the device is installed close to a light dimmer, an inverter electrical appliance or the remote control unit of a
hot-water system or floor-heating system, it may create interference and cause a malfunction.
• If the device is installed in an area with an extremely strong electrical field, such as in the vicinity of a
broadcasting station, it may create interference and cause a malfunction.
Precautions for mounting
• In 50Hz regions, if a strong fluorescent light shines directly into the camera, it may cause the image to flicker.
Either shield the camera from the light or use an inverter fluorescent light.
• Installing the device in the following locations could cause malfunction:
-
Locations exposed to direct sunlight
-
Locations that get hot
Close to a heater, boiler, etc.
-
Locations where there is risk of exposure to liquid, dust, oil, or chemicals
-
Locations with high humidity
Bathroom, basement, greenhouse, etc.
-
Locations with low temperature
Inside a cold storage warehouse, the front of a cooler, etc.
-
Locations directly exposed to steam or oil smoke
Next to heating devices or a cooking space, etc.
-
Sulphurous environments such as a hot spring area
-
Locations close to the sea or directly exposed to sea breeze
• If existing wiring is used, the device may not operate properly. In that case, it will be necessary to replace the
wiring.
• Do not, under any circumstances, use an impact driver to fasten screws. Doing so may cause damage to the
device.
Precautions
Installation Manual
1
