3
Make sure that power is not turned on at the controller
before making any connections to tool
.
1. Connect tool cable to the iEC controller and the tool:
The tool cable has curved alignment tabs and slots
built into the connectors at each end to ensure proper
alignment and connection with the tool and controller.
Align the female connector on the cable with the male
connector on the tool and insert the cable onto the tool, then
slide the connector nut onto the threads on the cable and
turn clockwise until hand-tight.
Align the male connector tab on the other end of the tool
cable with the female slot on the controller and insert the
cable into the connector, then slide the metal outer cover
onto the connection threads on the controller and turn
clockwise until hand-tight.
2. Multifunction Button Operation:
The tool will flash all LED lights three times when power is
first turned on at the controller. After the controller finishes
initializing and displays a target toque value, the
multifunction button (MFB) is used to toggle the tool from
clockwise mode (FWD) to counter-clockwise operation
mode (REV). The MFB is the small button opposite the
trigger.
The MFB is user configurable in the controller
software so this applies to factory default settings only.
The tool will initially start in clockwise mode and will have
no LED lights turned on. If the trigger is pressed, the tool
will turn on the blue LED once In Cycle Torque is reached
meaning the tightening operation is underway. Pressing the
MFB will cause all tool LED lights to flash. Pressing the MFB
again will switch the tool back FWD mode and will indicate
this with no LED lights turned on. (
Factory default setting
)
3. Start Lever Operation:
To start the tool, depress the start lever. Blue LED lights will
be displayed while tightening a bolt once In Cycle Torque is
reached. The tool will stop automatically when it senses its
target torque value or if no torque is sensed in a specified time
period. After a cycle is complete, the tool will display green
LED lights for a success, or red LED lights for failure to reach
torque/angle. Previous cycle result will remain lit until a new
cycle is started and surpasses In Cycle Torque setting.
Light Ring Light Assignment
The Buzzer and Multi-Function Button are configurable in
the Tool Controller Software.
Light Color
Meaning
Green Solid
OK
Red Flashing
Torque Low
Red Solid
Torque High
Yellow Flashing
Angle Low
Yellow Solid
Angle High
Blue Solid
Tool In-Cycle/Tool Armed
Blue Flashing
P-Set Change thru MFB
All On Flashing
Tool in Disassembly
Buzzer
Bad Assembly/Tool in Disassembly/Power Up
A complete tool system consists of the following items:
Controller
Power cord
Tool
Tool Cable
OPERATION
Multi-function
Button
Tool Body
Cable Connection
Angle Head
Square
Drive
Start Lever
