CHAPTER 6
RPM
12
13
MXG
6. RPM
MXG can get the RPM signal in the following ways:
n
From ECU
n
Through a square wave signal (from 5 to 50 V)
n
From the low voltage (from 150 to 400 V)
of the coil
6.1 RPM from ECU
To get RPM from the ECU please configure your MXG and enable RPM channel as explained in
section 10.1. RPM is one of the many data flowing from your ECU to MXG.
6.2 RPM via a 5-50 V Square Wave Signal or coil (150-400 V)
In case your engine is not managed by any ECU, MXG can read the signal from the low voltage
of the coil (whose peak can be from 150 to 400 V) or from a possible square wave (the peak
can be from 5 to 50V). The PIN labelled
"rpm"
reported in appendix
“Pinout”
receives the
signal:
The image shows an example of wiring for
the ignition system.
The output, labelled
“GREY TACH”
gives a
5-50V output that can be directly acquired
from EVO4. If the output is not available
from the ignition system, the system has to
be connected to the low voltage of the coil,
as shown in the following schematic.
Point 1
: Low voltage of the coil
Point 2
: Connected to the spark plug
Point 3
: Connected to the +12V of the
battery
After connecting the RPM signal, please use
the software Race Studio 3 for enabling the
RPM channel, as explained in section 10.1.
1
2
3
1
2
3
