Aim K-M-P - GCU2, Быстрый старт

Страница: 2 / 5

1
1
Software configuration
This document explains how to connect third party CAN expansion modules to AiM devices CAN2 bus.
The driver here documented allows to read data from a K-M-P GCU-2 module programmed with
default settings on the calibration software K-M-P GCU-2 interface. To correctly communicate with the
AiM device, it is necessary to check if the module is set with the following default parameters. Refer to
the manufacturer for additional details on the configuration procedure.
Baudrate:
1Mbit/s (1000kbit/s)
CAN ID 1:
2000 (0x7D0)
CAN ID 2:
2001 (0x7D1)
CAN ID 3:
2002 (0x7D2)
CAN ID 4: 2003 (0x7D3)
CAN ID 5:
2004 (0x7D4)
Please note
: In case this module is going to be used with different parameters, the user can set up a
custom driver from the
CAN Protocols
section of the AiM configuration software Race Studio 3. Check
the dedicated manual from the AiM website www.aim-sportline.com, Documentation –
Firmware/Software area.