Page 8
Figure 14 – Dome Cover and Access
Panel
Figure 16 – Control Board
Figure 13 – Video, Data, Alarm (optional)
and Power connectors
Figure 17 – Attach dome cover to wall mount
AUX2
GND
7
6
5
4
3
A+
B-
AC24V
Rs485
2
1
ALARMS
AUX1
BNC co n n e c to r
Vid eo C ab le
Alarm C able
Power C able
C ontrol C able
A la rm C a ble
co nne ction
D I P Switch
Video Cable Connection
P rotective Cover
P owe r Cable /C ontro l Cable Co nne ction
Metal B u tto n
G 1
1/2"
M 4Screw
3.3.
Wiring and Installing the Dome
Cover
The 4-position and 12-position terminal blocks are supplied in
the packaging of the PTZ dome. The BNC connector is not
supplied. Make the required connections based on the
diagram in Figure 13. The connectors themselves are also
labeled.
Remove the Dome Cover from the packaging. Open the
access panel by pressing the metal button shown in Figure 14.
The access panel flips down. Do not touch the AMP socket
when opening the panel.
Make the power, video, data and alarm (optional) connections
inside the Dome Cover. Feed excess wire back up into the
mount so that the access panel can close properly. See Figure
16 for connector locations.
Before closing the access panel, set the dip switches (see
Figure 16) to select the desired Camera ID, Protocol, and Baud
rate. Refer to the appendix of the Operation Manual for dip
switch information.
Close the access cover. Pre-wind the dome cover
approximately 5-full turns before screwing the dome cover
into the wall mount. This will prevent the wires from being
twisted once the dome is in place. Screw the dome cover into
the wall mount, and tighten the M4 set screw (from the
hardware kit) to lock it in place.
Apply power to the unit. Check to see the LED shown in
Figure 18 is lit. Disconnect power before proceeding.
