5
5.5 Disassembly and Mounting
1. Detach the hardware kit from the housing.
2. Use a screwdriver or socket to loosen the the
two M4 captive screws from the housing cover.
See FIGURE 1.
FIGURE 1 Loosening the Captive Cover Screws
3. Remove the cover from the base assembly by
grasping the cover and gently pulling forward.
See
FIGURE 2 Removing the Cover.
Rest the cover
onto the retaining slot to access the cradle area.
See FIGURE 3
FIGURE 2 Removing the Cover
FIGURE 3 Accessing the Cradle/Rail Assembly
4. Attach the housing to an appropriate mount or
pan/tilt. Use the instructions provided with the
mount or pan/tilt. The base assembly has eight
clearance holes for mounting. Use a minimum of
three M6 screws and nuts or three 1/4in. screws
and nuts (not provided). Lock washers are required
(not provided). Rotating the rail assembly will allow
access to the mounting holes. This can be
accomplished by loosening the three M4 screws.
See 5.11 Camera/Lens Orientation. It will be easier to
mount the base before installing the camera, but it
may be mounted anytime during the installation
process. See FIGURE 4.
FIGURE 4 Mounting the Base Assembly
Base Assembly
Cover
Rest Cover on
Retaining slot
Lens Control Cable
Cable Type
Jacketed Multiconductor Cable
Cable Size
Outside diameter between 4.3mm
and 11.9mm (0.170in. and 0.470in.)
Cable Shape
Round
Shield
Overall shielding
Conductors
Stranded 20 to 16 AWG wire
No. of Conductors
4 and 8
Conductor Insulation
Color coded
Sources
Belden 9552
Belden 9554
M4 Captive Screws
Rail Assembly
M4 Screws
Mounting Holes (x 8)
