Assembly and Operating Instructions
Ver. 1 06/2012 (2321)
3
ATTACHING THE HANDLE
1.
Insert the two ends of the blue handle into the circular holes at one end of the bath
board. Insert the handle, which is slightly curved to one side, so that the top of the
handle leans in, towards the middle of the bath board.
2.
Using the plastic handle fixing screws supplied, insert each in turn into the
corresponding hole on the bottom of the bath board and, holding the handle on the top
of the bath board, turn the plastic fixing screws until they are finger tight only. NB. Do
not use a screwdriver as this may damage the screws, if required a large coin may be
used carefully to assist with turning the screws.
ATTACHING AND ADJUSTING THE FEET
1.
Turn the bath board over so that the bottom of the board is facing upwards.
2.
Insert each foot into the slot on the underside of the bath seat.
3.
Turn the bath board over so that you can see the top of the board and locate the four
corresponding slots for each foot.
4.
Insert a plastic fixing screw through the slots into the narrow opening at the top of each
foot and, holding the foot to prevent it from turning, turn the fixing screw until it is finger
tight only. NB. Do not use a screwdriver as this may damage the screws, if required a
large coin may be used carefully to assist with turning the screws.
5.
Repeat for all four feet.
FITTING AND ADJUSTING THE BATH BOARD
1.
Turn the board over with the feet facing up.
2.
Loosen off the feet holding the plastic fixing screw in position.
3.
Turn the board over so that the feet are facing down.
4.
Place the board over the bath traversing its width.
5.
Reach underneath the board and push both sets of feet outwards evenly until they are
gripping the wall of the bath.
6.
Tighten off the plastic fixing screws. N.B. It is only necessary to tighten the fixing screws
finger tight.
7.
Do not over tighten them as this can cause damage to the thread and cause the product
to fail.
8.
Double check the feet are friction tight to the wall of the bath before use.
Always check the tightness of the board before each use
Always repeat the installation every time the board is removed
