DAC0061
________________________________________________________________________________________________
13
IMPORTANT SAFETY INSTRUCTIONS
1. For toxic vapors produced by spraying certain materials can create intoxication and serious
damage to health. Always wear safety glasses, gloves and respirator to prevent the toxic
vapor hazard, solvent and pointing paint coming into contact your eyes or skin. (see fig 1)
2. Never use oxygen, combustible or any other bottle gas as a power source or would cause
explosion and serious personal injury. (see fig 2)
3. Fluid and solvent can be highly flammable or combustible. Pls Use the tool only in well-
ventilated area, and avoid any ignition sources, such as smoking, open flames and decrial
hazard. (see fig 3)
4. Disconnect tool from air supply hose before doing tool maintenance and during non-
operation, for emerge stop and prevention of unintended operation, a ball valve near the gun
to air supply is recommend.
5. Use clean, dry and regulate compressed air rated at 2.0-3.5bar, never exceed maximum
permissive operating pressure
(see fig 4)
6. Never use homogenate hydrocarbon solvent, which can chemically react with aluminum and
zinc parts and chemically compatible with Alum. and zinc pats.
7. Never point gun at you and others at any time.
8. Before operating the tool, make sure all the screws & caps are securely tightened in case of
leaking;
9. Before painting, make inspection for free movement of trigger and nozzle to insure tool can
operate well.
10. Never modify this tool for any other applications. Only use parts, nozzles and accessories
recommended and accessories recommended by manufactures.
INSTRUCTIONS FOR OPERATION
PREPARATION
1. After unpacking the product, inspect carefully for any damage that may have occurred during transit. Make sure to
tighten fittings, bolts, etc., before putting unit into service.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer
’s instructions. Most materials will spray
readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Fill the canister about ¾ full and start the air compressor.
WARNING
DO NOT EXCEED Maximum Pressure of Spray Gun or any other parts in the compressor system.
5. After Connect the gun to air supply, please make sure that the fluid cap, container and air hose have been
connected tightly with spray gun.
6. Set up a piece of cardboard or other scrap material to use as a target and adjust for best spray pattern.
WARNING
Never aim or spray at yourself or anybody else which would cause serious injury.
7. Test the consistency of the material by making a few strokes on a cardboard target. If material still appears too
thick, add a small amount of thinner. THIN WITH CARE! Do not exceed paint manufacturer
’s thinning
recommendations.
Il
ma
ns
ää
tö
-
v
en
tti
ili
n
k
ok
oo
np
a
no
Neul
av
en
tt
iil
in k
ok
oo
np
a
no
FIN
1
图表
3
2
3
4
