6
The kettle’s “auto shut-off” function will launch after the water has boiled. You can stop
the boiling process at any time by lifting the on/off switch to the “0” (off) position or
lifting the kettle off the base.
Unplug the kettle.
Remove the kettle from the power base.
Carefully pour the water.
Return the kettle to the base.
DOUBLE DRY HEATING PROTECTION
If you have forgotten to add water or the water inside is below the minimum accepted
level, the metal sheet for dry heating protection of the temperature controller will
disconnect automatically when the kettle is switched on in order to protect the kettle
from being damaged by dry heating.
If the above situation happens, please turn off the power supply, unplug the kettle and
wait 10 minutes for it to cool down. Once this is done, the temperature controller
connects and the kettle will operate normally again.
Note: Do not add cold water in the kettle in an attempt to cool it down quicker – this will
decrease the life span of the kettle’s heating plate.
GENERAL
*Beware of hot steam Escaping from the lid
The kettle has seamless 304 stainless steel interior for quick boiling and col touch exterior which
makes the kettle safe to touch.
Always remove the kettle from the base before pouring.
To avoid the risk of splashing, pour slowly and do not over-tilt the kettle.
Do not tilt the kettle backwards - water might get on to the control area. If this happens,
let the kettle dry thoroughly before use – place it somewhere warm for 12 hours.
When you lift the kettle, you may see moisture on the base. Do not worry – it’s the
steam used to switch the kettle off automatically, which then condenses and escapes via
vents under the kettle.
