LU-VE Sweden AB
Tel:
+46 454 334 00
Södra Industrivägen 2 – 4
Fax:
+46 454 320 295
SE – 374 50 Asarum
Sweden
7
Dry Cooler Type DXP120
Dry Cooler Type DXP100/120
Air Cooled Condenser Type DCP100
6
Asarums Industri AB
Tel:
+46 454 334 00
Södra Industrivägen 2 – 4
Fax:
+46 454 320 295
SE – 374 50 Asarum
Sweden
Receiving and fitting
The product is subjected to thorough inspection of quality and function before leaving
the factory. If faults or damage due to transportation are detected on the product, the
point of sale is to be contacted without delay.
Assembly
1. Move the product to the place of
installation before removing the packing.
2. The cooler is provided with eyebolts
and shall only be lifted using these
according to instructions on the cooler.
3. Bolt the product direct onto a firm
base, or with vibration dampers, through
the pre-drilled mounting holes.
7
Dry Cooler Type DXP100/120
Air Cooled Condenser Type DCP100
Asarums Industri AB
Tel:
+46 454 334 00
Södra Industrivägen 2 – 4
Fax:
+46 454 320 295
SE – 374 50 Asarum
Sweden
Installation
Installations may only be made by
authorised persons
and in conformance
with national standards.
The cooler may not be connected to
other voltage or frequency than its
rated data.
The wiring diagram is attached to the fan
grille together with these instructions. The
safety switch may not be used for starting
and stopping. Do not fit cable supports
where they could damage the battery and
thus cause leakage.
Tubing installation
The product is to be filled with the amount
and type of heat transfer medium stated by
the installation engineer. The connecting
tubes are located on one end of the unit.
The air vent is at the highest point of the
manifold tube (1).
The incoming lead is connected to tube (2).
The return lead is connected to tube (3).
The drain (4) is located at the bottom of the
manifold tube.
The cooler is to be connected to the safety
switch as follows:
Unscrew the screws (1) with a
screwdriver and remove the cover (2).
Connect the cable through the screw
fitting (3) on the side of the cover.
N.B.
Ensure that the fan rotates in the
direction indicated by the arrow.
1
2
3
1
2
3
4
1
2
3
