Commissioning
3. Activate the relay using the command ´
ipp f1 Rpp
´,
Deactivate the relay using the command ´
ipp f1 R-pp
´.
Application Driving the analog output :
1. Configure analog output port 6 or 7; see Manual 6.10.7:
e.g. selected analog type x (command ´
ipp f9 Ax
´)
assigning to the selected measuring point (command ´
ipp f9 E-00
´)
or assigning to any reference channel xx (command ´
ipp f9 Exx
´)
or output the value yyyyy via the interface (command ´
ipp f9 ayyyyy
´)
2. Define the desired measuring range for the measuring point, to be output
over the whole analog output range (0 to 10 V or 0 to 20 mA), using the pa -
rameters analog start and analog end in sensor programming, special func-
tions, see Manual 6.10.7.
3. If for a current output the output range 4 to 20 mA is to be used (instead of 0
to 20 mA), the element flag for 4 to 20 mA must be activated for the appro-
priate measuring point; see Manual 6.10.3.
8. Display and operating controls
The adapter incorporates a graphics display that can show exactly all states
affecting the interface elements. This is configured largely by the device itself.
8.1 Main menu
The main menu is called up by pressing
<MENU>
. Here, by pressing
▲
/
▼
, you can
access menu items
All ports
or
Single ports
or
Device configuration
and then, by press-
ing
►
or
PROG
, activate these.
By means of
<☼ON>
you can switch on dis-
play illumination.
8.2 Showing all elements :
Below the port number the type of elements
available is shown with its abbreviation. Below
this the activation status of the relays and trig-
ger inputs is shown and in line xy23 the actual
switching status of the relays and the type of
analog outputs.
8.3 Showing single elements :
You can by pressing
▲
and
▼
scroll
through and select any port individually and
display details of address, element type, vari-
ant, and status.
With
relays
one can also see the actual
switching status of the individual contacts.
ALMEMO
®
8006-RTA3
7
