4. Post driver Tools
4.1 Tool Replacement
1)
Remove the stop pin and the tool pin
with a 330mm-long steel bar.
When reassembling, align the groove in the tool and
the tool pin hole and insert the tool pins.
2)
Reverse disassembly procedures to install
a replacement too.
-
Before installing a new tool, check each part forwear,
breakage, scores, etc.
-
Remove burrs and swellings on each tool pin,
apply a coat of grease to the movable areas of
the tool pin and the tool and finally install thetool.
-
Excessively deformed the tool pins will
make replacement of the tool difficult. The tool pins
must be checked every 100 to 150 hours of operation.
If the replacement tool is not a genuine part, we do not
guarantee the performance of other parts of the Post driverhammer.
Ensure that the tool shank is well lubricated before inserting it into the tool holder.
Keep tools well-greased and sheltered from the weather when not in use.
A rusty tool is more likely to suffer fatigue failure.
The standard inner diameter of the bottom portion of the driver chisel is 200mm.
Stop Pin
Tool Pin
https://www.agrotkindustrial.com
/
