Agromehanika AGS 2500 EN-HP, Инструкция по эксплуатации

Страница: 111 / 131

AGS 2500/3000 EN-HP USER MANUAL – rev.2016/12
page
101
If the tractor has an output signal for measuring speed, signal from the tractor is used instead
of no-contact sensor. In this case, the tractor connector is connected to AG-TRONIK 14.
Required connection cable code: 018.60.530. Speed constant for input in AG-TRONIK 14 is
1024.
NOTE: speed constant applies to standard tractor wheels. If you have changed
wheel type, a new constant must be entered. (chapter »PROGRAMMING«;
subchapter »SPEED CONSTANT«).
Appearance of connection connector for speed
gauge. The connector is standardized and is the same
for all tractor.
12.3.7 Electrical connection cabinet
All sensors and motors are connected in electrical connection cabinet, where processor part of
AG-TRONIK is also fitted. On command cabinet of AG-TRONIK are display, buttons and
circuit, required for communication with electrical connection cabinet. Connection AG-
TRONIK – electrical connection cabinet is made with connection cable and serial
communication mod-bus. Cabinet, in addition to processor part, also includes power part with
automatic fuses, relays, connection clamps... Engine protection is provided for by automatic
fuses. In case of short-term overload, fuse disengages and reengages in the next moment. If
there is a serious motor fault and the fuse does not engage, fault must be remedied by
authorized service of Agromehanika.
Speed sensor is connected to bottom part of connection cabinet (4-pole connector). Flow
sensor is connected to connection cabinet through connection clamps.
Figure 63 ELECTRICAL CONNECTION CABINET