38
(VII) Shutdown and Inspection of Diesel Engine
1. Before the engine has been shut down,it should make sure the gear has been positioned in
neutral and the vehicle has been in the empty load condition.
2. Diesel engine shall be operated at low speed for 3-5 minutes before shutdown so as to be cooled
down completely, during which the engine shall be checked for leakage of water, oil and gas and
abnormal sound.
3. Turn the key switch to “OFF” and disconnect the general supply for vehicle.
4. When the ambient temperature is below 0
℃,
the drainage valves of engine block and w ater tank
shall be opened after shutdown to drain the cooling water fully and prevent the block, water pump and
radiator from frost damage. If antifreeze fluid at proper temperature is used, the drainage is not
required.
(VIII) Security Warning
1. When diesel engine is running, do not contact fan, belt pulley, belt and other exposed area of
rotating parts so as to avoid being hurted by them.
2. Operator is not allowed to open the water filler cap on radiator immediately if diesel engine is hot
so as to avoid being scalded by high-temperature water vapor.
3. When diesel engine is hot, do not contact exhaust pipe and other high-temperature parts so as to
Содержание TX920L
