Agri-Fab Mow-N-Vac 45-04072, Руководство пользователя

Страница: 8 / 28

8
AXLE
REAR
TONGUE
LATCH STAND
BRACKET
15. To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside down
on its top flanges, so that the wheel support is facing
up. See figure 9.
16. Lay the drawbar tongue onto the Wheel Support and
the Latch Stand Bracket. Assemble the axle through
the wheel support and the tongue. See figure 9.
COTTER PIN
WHEEL
FLAT
WASHER
FLAT
WASHER
AXLE
AXLE
CLIP
IMPORTANT:
Make sure drawbar tongue is securely
locked to the latch stand bracket by the latch lock lever.
17. Assemble a flat washer, a wheel with the valve stem
facing out, another flat washer and an axle clip onto
the axle as shown in figure 10. Secure the wheel on
the axle with a cotter pin, spreading the ends. Repeat
on other end of axle.
FIGURE 9
FIGURE 10
TONGUE
(FRONT)
3/8" NYLOCK
NUT
3/8" x 1"
HEX BOLT
HITCH
BRACKET
FIGURE 11
18. Assemble the hitch bracket to the front tongue using two
3/8" x 1" hex bolts and 3/8" nylock nuts. See figure 11.
5/16" x 4"
HEX BOLT
SPRING
LATCH
LOCK
LEVER
5/16" LOCK NUT
FIGURE 8
13. Insert the latch lock lever into the rear tongue as shown
in figure 8A. Secure it in place using the 5/16" x 4" hex
bolt and 5/16" nylock nut.
14. Attach the spring to the hole in the rear tongue and
the lower hole in the latch lock lever as shown in figure
8B.
B
a