Agri-Fab 45-0540, Руководство пользователя

Страница: 9 / 24

9
FIGURE 10
14. Place a hose clamp onto one end of hose. Push hose
onto hose adapter (nozzle). Tighten hose clamp onto
hose and hose adapter.
Do not collapse hose adapter
when tightening clamp. See figure 10.
15. Place the hose hanger rod into the hose hanger bracket
on the impeller housing assembly. See figure 10.
16. Loop the 25" tarp strap under the hose. Hook to the
hose hanger rod. See figure 10.
FIGURE 11
HINT: Tip the cart bed back for easier access.
17. Attach the chipper chute assembly to the weld bolts
on the back side of the impeller housing using three
5/16" flat washers and 5/16" Nylock nuts.
Tighten.
See figure 11.
25" TARP
STRAP
HOSE HANGER ROD
HOSE
CLAMP
FIGURE 8
11. Assemble the elbow to the impeller housing using
four 5/16" x 3/4" self tapping hex bolts and four nylon
washers. Push while turning to help start the bolts into
the unthreaded holes.
Tighten.
See figure 8.
5/16" x 3/4"
HEX BOLT
(Thread Forming)
NYLON
WASHER
12. To align the elbow with the opening in the hard top:
a. Push the vinyl boot back inside the opening.
b. Loosen by approximately 1/2 turn each, the six
bolts that you assembled that fasten the engine base
to the tongue. See figure 9.
c. Slide the engine base assembly sideways until the
elbow is aligned with the opening in the hardtop.
d.
Retighten the six bolts that you loosened.
13. Pull the vinyl boot onto the end of the elbow.
Loosen (6) bolts
1/2 turn each
Align elbow with opening
FIGURE 9
5/16"
NYLOCK
NUT
5/16" FLAT
WASHER
CHIPPER CHUTE
ASSEMBLY