5
4. Remove the pivot pin and the slotted hex nut from
the mast assembly as shown in figure 4. Attach
the weight tray to the end of the mast assembly
using a 3/8" x 1" hex bolt and a 3/8" Nylock hex
nut. Tighten nut and bolt.
5. Reinstall the slotted hex nut onto the threaded
stud. Tighten the slotted nut, aligning a slot with
the drilled hole in the stud. Reinstall the cotter pin
through the hole in the stud. See figure 4.
6. Reinstall the pivot pin and secure the it with the
haircotter pin. See figure 4.
1. Before starting, make sure the material to be
moved or conditioned is dry enough by squeezing
some in your hand. If it forms a ball that doesn't
crumble, the material may be too wet to work.
2. The box scraper scarifiers can be set to penetrate
the ground to depths of 1/2" to 3-1/2" in 1" incre-
ments. To change the depth, remove the clevis pin
that attaches each scarifier tooth to the box scraper
and relocate the pin in another hole of the tooth.
Be sure to use the same hole in each scarifier
tooth. See figure 5.
CAUTION: USE CARE WHEN WORKING
AROUND A RAISED BOX SCRAPER.
KEEP YOUR FEET AND HANDS FROM
UNDER THE BOX SCRAPER AT ALL
TIMES. SERIOUS INJURY CAN RESULT
SHOULD THE BOX SCRAPER DROP
UNEXPECTEDLY.
FIGURE 5
ADJUST DIGGING
DEPTH OF SCARIFIER
TOOTH BY RELOCATING
CLEVIS PIN IN ANOTHER HOLE
FIGURE 4
SLOTTED
HEX NUT
PIVOT
PIN
COTTER PIN
3/8" x 1"
HEX BOLT
3/8" NYLOCK
HEX BOLT
HAIRCOTTER PIN
WEIGHT
TRAY
OPERATION
The box scraper is an attachment used with the grader
blade. The box scraper breaks up, levels, finish grades,
and scarifies the ground for soil preparation.
IMPORTANT:
Do not swivel the grader blade. The
grader blade must remain locked in the straight ahead
position when the box scraper attachment is used.
3. Any time the box scraper is to be stored on a hard
surface, raise each scarifier tooth by relocating
the clevis pins to the bottom hole in each tooth
before lowering the scraper.
MAINTENANCE
1. Check for and tighten any loose hardware before
each use.
2. Clean the box scraper and lightly oil only bare
metal after each use.
3. Remove all dirt and rust. Touch up paint before
placing box scraper in storage.
4. Store box scraper inside a dry area.
Содержание 45-0358
Страница 6: ...6...
