ASSEMBLY INSTRUCTIONS
(SEE ILLUSTRATION BELOW)
1. Assemble bearings (Ref. 5) into hitch tubes (Ref. 3) so
that bearing flange is against outside of hitch tube.
You
may need to place a block of wood against bearing
and carefully tap with a hammer.
2. Place hitch tubes (Ref. 3) onto both ends of roller shaft.
Assemble a flat washer (Ref. 6) onto each end of roller
shaft and secure with two cotter pins (Ref. 12).
3. Assemble scraper bar (Ref. 2) to hitch tubes (Ref. 3)
using two hex bolts (Ref. 9) and hex lock nuts (Ref. 10).
Do not tighten yet.
4. Assemble ends of hitch tubes (Ref. 3) together using
two hex bolts (Ref. 7) and hex lock nuts (Ref. 10).
Do
not tighten yet.
5. Assemble hitch brackets (Ref. 4) to hitch tubes (Ref. 3)
using two hex bolts (Ref. 8) and hex lock nuts (Ref. 10).
Do not tighten yet.
6.
Tighten
bolts and nuts starting with scraper bar (Ref.
2), then ends of hitch tubes (Ref. 3), and finally hitch
brackets (Ref. 4).
7. Install hitch pin (Ref. 13) through hitch brackets (Ref. 4)
and secure with hair cotter pin (Ref. 14).
8. Adjust plug (Ref. 11) size by twisting handle. Lock a plug
in each end of roller drum by flipping handle down.
1
11
11
2
3
3
4
5
5
6
6
7
8
9
9
10
10
15
15
12
12
10
13
14
10
1
-----
1
Roller Drum (Not sold separately)
2
24868 1
Scraper Bar
3
48376 2
Hitch Tube
4
24192 2
Hitch Bracket
5
43632 2
Bearing, Plastic
6
43528 2
Flat Washer, 1"
7
46782 2
Hex Bolt, 5/16-18 x 3"
8
43224 2
Hex Bolt, 5/16-18 x 2-1/4"
9
43084 2
Hex Bolt, 5/16-18 x 1-3/4"
10 47810 6
Hex Lock Nut, 5/16-18
11 49467 2 Plug, Lawn Roller
12 43501 2
Cotter Pin, 5/32" x 1-1/2"
13 47623 1
Hitch Pin
14 43343 1
Hair Cotter Pin 1/8"
15 23625 2
Spacer
Ref. Part Qty.
Description
No. No.
Ref. Part Qty.
Description
No. No.
Figure 1.
Instructions for tightenting plug
■
Pull plug firmly in opposing directions
■
Twist ring counter-clockwise to tighten
NOTE:
If the outer washer is not functioning properly, use a pair of
needlenose pliers to ensure that it is free.
Plug Adjustment (See Figure 1)
